Nail anchor FNA II with nail head

Product description
• Galvanised steel
• Connects the operating principle advantages of a bolt anchor with those of simple impact mounting
• Tightening torque is not required to expand the anchor
It expands itself after being subjected to a load. In doing so, the cone is pulled into the expansion clip and it braces against the borehole wall
• Fixes suspended ceilings, cable channels, wall cladding, fire protection panels etc.
Approved for:
• Use as (redundant) multiple fixing of non-load-bearing systems in cracked concrete C12/15 to C50/60, also in the tensile area
Also suitable for:
• Natural stone with dense structure
• Solid sand-lime brick
• Pre-stressed hollow ceiling panels
For attaching:
• Strips
• Metal profiles
• Wire and vernier suspending brackets
• Chains
• Perforated tapes
• Fire protection bulkheads
• Fire protection cladding
• Ventilation cables
• Substructures made of wood and metal
• Ceiling cladding
• Metal clamps
• Plasterboard

Advantages:
• Really easy to set: drill it, knock it in, all done!
• Only 2-4 hammer blows and the FNA II is fitted
• Also suitable for pressure-resistant attachments (wood, plasterboard, ...)
• Extremely small anchoring depth of 30 mm reduces drilling time - this saves time and reduces reinforcement strikes
• The highest degree of tensile strength up to a permissible load of 2.4 kN
• Small axis and edge distances, even for applications with small component dimensions (e.g. only for slim 10 cm beams)
• For component thicknesses from 8 cm
• Test loads that were previously common are not required!
• The first ceiling anchor with European technical approval in low-strength concrete C12/15 (B15)

• Pre-positioned/feed-through mounting
• Drill ø: 6 mm
• Min. anchorage depth: 30 mm
• Head ø: 13 mm