Tubular guide elbow set Flipflex 20

Measuring:
Dimension from the unfinished floor to the lower edge
Measure tap block. Mark the
pipe in accordance with the table included..

Pushing over:
Push the flipflex over the pipe up to the marked
point.

Bending:
Bend the flipflex including the pipe with a flick of the
wrist. This is particularly easy if you
encompass both ends of the flipflex as you do so!

Connecting:
Push the screw connection onto the
calibrated pipe and tighten on the tap block.

Fixing:
Connect the two pipelines on the flipflex
with the fixing bracket.
Nail it to the floor.

Securing:
To ensure the accurate centre distance,
put the double clip on the top.

• Radius: 100 mm
• Internal ø: 20.8 mm
• For pipe ø: 20 mm
• Length: 250 mm

Innovation awards winner 2001